In BIRD, RX has lower priority than TX with the exception of RX from
control socket. The patch replaces heuristic based on socket type with
explicit mark and uses it for both control socket and BGP session waiting
to be established.
This should avoid an issue when during heavy load, outgoing connection
could connect (TX event), send open, but then failed to receive OPEN /
establish in time, not sending notifications between and therefore
got hold timer expired error from the neighbor immediately after it
finally established the connection.
If the number of sockets is too much for select(), we should at least
handle it with proper error messages and reject new sockets instead of
breaking the event loop.
Thanks to Alexander V. Chernikov for the patch.
Although RFC 3542 allows both cases, Theo de Raadt thinks
he knows better, and msg_controllen without last padding
fails on OpenBSD.
Thanks to Job Snijders for the bugreport.
I/O:
- BSD: specify src addr on IP sockets by IP_HDRINCL
- BSD: specify src addr on UDP sockets by IP_SENDSRCADDR
- Linux: specify src addr on IP/UDP sockets by IP_PKTINFO
- IPv6: specify src addr on IP/UDP sockets by IPV6_PKTINFO
- Alternative SKF_BIND flag for binding to IP address
- Allows IP/UDP sockets without tx_hook, on these
sockets a packet is discarded when TX queue is full
- Use consistently SOL_ for socket layer values.
OSPF:
- Packet src addr is always explicitly set
- Support for secondary addresses in BSD
- Dynamic RX/TX buffers
- Fixes some minor buffer overruns
- Interface option 'tx length'
- Names for vlink pseudoifaces (vlinkX)
- Vlinks use separate socket for TX
- Vlinks do not use fixed associated iface
- Fixes TTL for direct unicast packets
- Fixes DONTROUTE for OSPF sockets
- Use ifa->ifname instead of ifa->iface->name
RIP sockets for multiple ifaces collided, because we cannot bind to
a specific iface on BSD. Workarounded by SO_REUSEPORT.
Thanks to Eugene M. Zheganin for the bugreport.
Interfaces for OSPF and RIP could be configured to use (and request)
TTL 255 for traffic to direct neighbors.
Thanks to Simon Dickhoven for the original patch for RIPng.
Implements support for IPv6 traffic class, sets higher priority for OSPF
and RIP outgoing packets by default and allows to configure ToS/DS/TClass
IP header field and the local priority of outgoing packets.
Several new configure command variants:
configure undo - undo last reconfiguration
configure timeout - configure with scheduled undo if not confirmed in timeout
configure confirm - confirm last configuration
configure check - just parse and validate config file
Which was, actually, a bug in timers - on older kernel, monotonic timer
is missing and the other implementation started with now == 0, which
collides with usage 0 as a special value in timer->expires field.
- Adds check to deny config file with no specified protocol to prevent
loading of empty config file.
- Moves CLI init before config parse to receive immediate error message
when cannot open control socket.
- Fixes socket name path check and other error handling in CLI init.
