I/O:
- BSD: specify src addr on IP sockets by IP_HDRINCL
- BSD: specify src addr on UDP sockets by IP_SENDSRCADDR
- Linux: specify src addr on IP/UDP sockets by IP_PKTINFO
- IPv6: specify src addr on IP/UDP sockets by IPV6_PKTINFO
- Alternative SKF_BIND flag for binding to IP address
- Allows IP/UDP sockets without tx_hook, on these
sockets a packet is discarded when TX queue is full
- Use consistently SOL_ for socket layer values.
OSPF:
- Packet src addr is always explicitly set
- Support for secondary addresses in BSD
- Dynamic RX/TX buffers
- Fixes some minor buffer overruns
- Interface option 'tx length'
- Names for vlink pseudoifaces (vlinkX)
- Vlinks use separate socket for TX
- Vlinks do not use fixed associated iface
- Fixes TTL for direct unicast packets
- Fixes DONTROUTE for OSPF sockets
- Use ifa->ifname instead of ifa->iface->name
Interfaces for OSPF and RIP could be configured to use (and request)
TTL 255 for traffic to direct neighbors.
Thanks to Simon Dickhoven for the original patch for RIPng.
A very tricky bug. OSPF on NBMA interfaces probably never really worked.
When a packet was sent to multiple destinations, the checksum was
calculated multiple times from a packet with already filled checksum
field (from previous calculation). Therefore, many packets were sent
with an invalid checksum.
Cryptographic authentication in OSPF is defective by
design - there might be several packets independently
sent to the network (for example HELLO, LSUPD and LSACK)
where they might be reordered and that causes crypt.
sequence number error.
That can be workarounded by not incresing sequence number
too often. Now we update it only when last packet was sent
before at least one second. This can constitute a risk of
replay attacks, but RFC supposes something similar (like time
in seconds used as CSN).
values for MD5 password ID changed during reconfigure, Second
bug is that BIRD chooses password in first-fit manner, but RFC
says that it should use the one with the latest generate-from.
It also modifies the syntax for multiple passwords.
Now it is possible to just add more 'password' statements
to the interface section and it is not needed to use
'passwords' section. Old syntax can be used too.
